Fagor 8055 FL, Operating Manual

Page: 186 / 210

·186·
Operating manual
CNC 8055
CNC 8055i
6.
SAVING PROGRAMS
·TC· O
PTION
S
OFT
: V02.2
X
List of
saved programs
6.1 List of saved programs
The CNC will display the following information:
Press one of these keys to exit the directory or list of part-programs:
List of part-programs.
The left side shows the list of part-programs that are saved in the CNC's memory. Use the [

][

]
keys to move the pointer over the list of programs. Use the [SHIFT][

] y [SHIFT][

] keys to scroll
a page at a time.
It is possible to select the program by typing its number directly. If the desired program does not exist,
the cursor will go to the nearest previous one. For example, to find program number 123, press the
keystroke sequence [1], [2] and [3]. The time interval between keystrokes must be shorter than 1.5
seconds. A longer interval starts a new sequence.
Cycles that make up the part-program.
The right column shows the cycles and/or blocks edited in ISO code that make up the part. Once
the list of programs has been selected, the following operations are possible:
• Creating a new part-program.
• Seeing the contents of a part-program.
• Deleting a new part program.
• Copying a part-program into another one.
• Modifying a part-program.
Press [P.PROG] to access the list of saved part-programs.
It is not possible to access the list of part-programs directly if the "Tool calibration" mode
is selected. First, quit this mode; in other words, first press [ESC] and then [P.PROG].
P.PROG
15:28:42 IN POSITION
PROGRAMS - PARTS CYCLES
1 - XFT123
2 - ABZ 2343
22 -
23 -
128 - MTB 234A
285 - XFT 127B
764 -
777 -
832 - ABZ2347C
833 -
1234 -
1236 - MTB 238
1245 - MTB 3434 1.- POSITIONING 1
2.- TURNING CYCLE 1
3.- TAPER TURNING CYCLE 1
4.- ROUNDING CYCLE 2
ISO
ESC