Fagor 8055 FL, Operating Manual

Page: 189 / 210

Operating manual
CNC 8055
CNC 8055i
SAVING PROGRAMS
6.
·TC· O
PTION
S
OFT
: V02.2
X
·189·
Savin
g
an ISO block or a cycl
e
6.4 Saving an ISO block or a cycle
The block or cycle may be added at the end of the program, after the last operation or insert it between
2 existing operations.
To save the block or cycle, proceed as follows:
1. Define the desired block or cycle assigning the relevant data to it.
2. Press [P.PROG] to access the list of part-programs stored.
3. Select, with the pointer, the desired program number on the left column and switch over to the
right column.
4. Place the pointer on the operation after which the block or cycle is to be saved and press
[ENTER].
Example:
To insert the "turning cycle" operation, once the operation has been defined, place the pointer on
the "taper turning cycle 2" operation and press [ENTER].
To insert the "threading cycle 1" operation, once the operation has been defined, place the pointer
on the last "taper turning cycle 1" operation and press [ENTER].
Current program Desired program
Positioning cycle 2 Positioning cycle 2
Facing cycle Facing cycle
Taper cycle 2 Taper cycle 2
Turning cycle
Rounding cycle 2 Rounding cycle 2
Taper cycle 1 Taper cycle 1
Threading cycle 1