The manufacturer instructions that come with your accessory should have markings for wires or
terminals to connect to the gate opener. Please look for terminals named below in the instructions
for the accessory.
Keypads, Receivers:
Normally Open (NO) or Input (INP) or Relay of entry device
= #1 ter minal on gate opener
control board.
Common (COM) or Ground (GND) or Relay of entry device
= #13 ter minal on gate opener
control board.
12V Power positive (+) or (12V) or (PWR) of entry device
= #11 ter minal on gate opener
control board.
12V Power Negative (
-
) or (GND) or (PWR) of entry device
= #12 ter minal on gate opener
control board.
Push Button, Intercoms:
Normally Open (NO) or Input (INP) or Relay of entry device
= #1 ter minal on gate opener
control board.
Common (COM) or Ground (GND) or Relay of entry device
= #13 ter minal on gate opener
control board.
Push buttons do not require power and Intercoms draw too much power to power from the
gate opener.
Exit Wand/Sensor, Exit Loop Detector, Exit Device:
Normally Open (NO) or Input (INP) or Relay of exit device
= #1 terminal on gate opener
control board.
Common (COM) or Ground (GND) or Relay of exit device
= #14 ter minal on gate opener
control board.
12V Power positive (+) or (12V) or (PWR) of exit device
= #11 terminal on gate opener con-
trol board.
12V Power Negative (
-
) or (GND) or (PWR) or Shield wire of exit device
= #12 terminal on
gate opener control board.
*Be sure the A parameter is set to 1
Accessories Wiring
9.5
Estate Swing
Summary of Contents for Estate Swing E-S 1100 Series
Page 51: ...9 4 Estate Swing...