3.6
12.
Remove the operator arm from the brackets. Leaving the brack-
ets clamped in place
mark your holes
. If you are bolting your brack-
ets in place, remove the mounting brackets and drill the marked
holes using a power drill with a 3/8” drill bit for the post and 1/4”
drill bit for the gate.
Tip:
Using a level on top of the drill as a guide helps you to keep
your holes level.
Lift up on arm
13.
Attach the mounting brackets either using a carriage bolt or lag bolt with a washer on both
sides of the structure and a nut on the back side of the structure
or
by welding. Always take the
proper precautions, protective eyewear, etc. when drilling or welding.
14.
After properly affixing the mounting brackets insert the arm
fittings into the mounting brackets. Using the provided nut and
washer on the bottom of the threaded rear fitting attach the arm to
the post mounting bracket.
15.
With the arm pin still turned 5 turns from the end position,
insert the pin in the gate mounting bracket and bushing. With
the front fitting in the gate mounting bracket and bracket
bushing, turn the manual release key
clockwise 2 turns until
the
gate
reaches
its
full closed position.
Insert the arm in the
brackets
Estate Swing
Summary of Contents for Estate Swing E-S 1100 Series
Page 51: ...9 4 Estate Swing...
