3.3
4.
Measure the 5”x5” setback that was elaborated on in the
beginning of this section.
7.
Check your operator arm. The pin should be stopped on the front part of the operator arm. If
the pin is not,
turn the manual release key in the front lock hole clockwise until it reaches the
front stop position.
Extend the operator pin in this manner ONLY. Any other method may damage the arm.
NOTE:
The front stop position
IS NOT THE FULL CLOSED POSITION,
it is
the common point of reference for counting manual turns.
5.
Using the rear hole on the “tear” shaped bracket, drill a
5/16” diameter hole in the “L” shaped bracket.
6.
Inset the 5/16” bolt in the drilled rear hole. Tighten the
nuts on both bolts and leave the combined brackets
clamped to the post.
Estate Swing
Summary of Contents for Estate Swing E-S 1100 Series
Page 51: ...9 4 Estate Swing...
