FAAC DAAB EP104, Instruction Manual

Page: 45 / 74

DAAB STYRAUTOMATIK EP104
45
Instruction manual version 1 for software version 4.04
INSTRUCTION MANUAL FOR DAAB EP104 CONTROL BOARD
Vehicle loop 2
No. Name Range Factory Setting Ref. page
d200 Use loop 2 0 - 1 0 33
0 Input disabled
1 Input enabled
d201 Loop reading x1 000-999 33
d202 Loop reading x1000 00-99 33
d203 Activation from passing vehicle 000-999 33
d210 Detection limit for a vehicle in the loop 05-99 15 33
d211 Difference between on and off in the loop 00-50 03 33
d220 Loop presence reset 000 and 005-240min 120 33
d221 Fast loop presence reset 00-99 sec 00 33
d231 Compensation for the influence of the door half
operated by motor 1 on the loop in the close
position
00-50 03 33
d232 Compensation for the influence of the door half
operated by motor 2 on the loop in the close
position
00-50 03 33
d240 Safety function in closing movement 0 - 3 1 34
0 Disabled
1 Reversal
2 Stop with automatic restart of automatic closing
3 Stop without automatic restart of automatic closing, wait for new control signal
d241 Safety during run-on time in closing movement 0 - 1 1 34
0 Disabled
1 Enabled and subordinated to d240
d242 Safety function in opening movement 0 - 3 0 34
0 Disabled
1 Reversal to fully closed
2 Stop with automatic restart of automatic closing
3 Stop without automatic restart of automatic closing, wait for new control signal
d251 Loop closing 0 - 1 0 33
0 Disabled
1 Enabled
d254 Type of closing with loop 0 - 1 1 33
0 Close immediately when loop is clear
1 Open fully first, then close
d260 Control function 0 - 1 0 33
0 Disabled
1 Open