FAAC A1000, User Manual, Page: 30 / 116

A1000 30 532210 04 - Rev.A
1
29
30
31
1
8
6
Nm
Tr
ansla
tion of the original instruc
tions
ENGLISH
9.2 MOUNT PROFILES ON THE LEAVES
!
Before installing the leaves, ensure there is no cutting or dragging hazard.
Check leaf verticality.
Remove any protrusions and/or sharp edges on the frame and leaves.
1. Position and fasten the attachment profile onto the top of the
leaf
29
.
!
Use suitable screws for the weight of the leaf with adequate tightening
torque.
2. Position and fasten the lower guide profile onto the bottom of
the leaf
30
.
9.3 MOUNT THE LOWER SWEEPER
(OPTIONAL ACCESSORY)
1. Cut the sweeper to the same length as the leaf.
2. Insert the brush into the appropriate housing in the lower guide
profile
30
- .
GLASS LEAVES
 
For installation of glass leaves see the dedicated section: § 10
 32
.
9.4 INSTALLING THE LEAVES
Install each leaf as described below.
1. Disassemble the 2 carriages:
-
Remove the 2 fastening screws
31
- .
-
Separate the top plate of the carriage from the bottom plate
31
- .
2. Slowly insert the lower plates of the carriage into the profile
31
- .
3. Adjust the position of the two plates on the leaf.
-
Keep to the measurements indicated in diagrams
91 92
93
and the positions shown in figures:
- 94
for RIGHT single leaf automations
- 95
for LEFT single leaf automations
- 96
for DOUBLE leaf automations
4. Fasten the plates of the carriages using the 2 screws
31
- .
For manual lifting, there should be 1 person for every 20 kg to be lifted.
!
Adjust the counter wheel
34
.
 
Screws not supplied.