EZ EZ-220, Hardware Manual

Page: 60 / 150

56
EZ-TEXT-M-E
Text Panel Hardware Manual
again. Type in a “ C ” immediately after the “ 111 . 1 ”. (DATA 1 will
appear as four, red ones in the message.)
e. Under the DATA 1 section of the screen shown above, type in
“V2010” in the PLC Address fi eld. The Data Type should be set
to BCD , and Access should be Read Only .
f. Click on the Press to accept Message edit button.
g. The last Local Message to be confi gured will be an Interactive
message ( DATA 1 ).
h. Click on the Process Control
Folder, then click on Add Local
Message .
i. In the Message Text fi eld, type
in “Load Part #” , leave a space,
and then press F5, or Ctrl + 1, four times. ( DATA 1 will appear in
the Message Text fi eld as four, red ones.)
j. The DATA 1 confi guration area is now available (no longer grayed
out.) Next to PLC Address , type in “V2011” . Data Type should
be BCD . Access is Read/Write . Set the Min. value to “1200”
and the Max. value to “1999” (settings are shown in the screen
capture, above.) This will limit what value can be entered by the
operator.
k. Click on the Press to accept Message edit button to save it.