EZ EZ-220, Hardware Manual

Page: 21 / 150

17 EZ-TEXT-M-E
Text Panel Hardware Manual
2. The recessed slot(s) where the labels are inserted
should now be visible.
3. Remove the factory installed label insert.
4. Use the corner of the ramp tool to lift the top layer of the
overlay (shown in illustration #3), just enough to
place the custom label into the slot. Hold the overlay
up with the ramp tool and start the custom label into
the slot (illustration #4).
5. Once the label has been placed into the slot, move the
ramp tool behind the label insert and use as a ramp to
guide the label insert into the slot until properly
positioned (illustration 5).
6. Push label tab down into trim channel with the ramp
tool (illustration 6).
7. Replace the rubber trim by fi rmly pressing the barbed
rib into the molded channel in the front panel housing.