EZ EZ-220, Hardware Manual

Page: 99 / 150

95 EZ-TEXT-M-E
Text Panel Hardware Manual
14. Do the EZSeries Set Point Display Text Panels support discrete
addresses?
No, the EZSeries Set Point Display Text Panels do not support discrete
addresses. All addressing for the EZSeries Set Point Display Text
Panels must be in Word format.
15. How do I insert a PLC Message?
In order to insert a PLC Message, there must be a gap in the message
numbers. For example, I have PLC Message #1 and PLC Message
#3 programmed. If I click on PLC Message #3 and click the INSERT A
PLC MESSAGE button, PLC Message #2 will be inserted between PLC
Messages 1 and 3.
16. Can I renumber PLC Messages?
Yes, you can renumber PLC Messages; however, when changing
a message number to a higher message number, all unused lower
message numbers will be sent as “blank” messages when the project
is transferred to the panel. Blank messages will count towards the
maximum number of allowed messages in a project (256).
17. Can you copy and paste messages?
Yes, you can copy and paste messages. Currently, however, you can
copy or paste only one message at a time.
18. It is hard to read the display on my panel. It’s too bright. Is there a
way to adjust the contrast?
Yes, to adjust the contrast on the display, simply place the panel into
Setup Mode. While in Setup Mode you can use the up and down arrow
keys to adjust the contrast.
19. How do I enter new or change existing values on my EZSeries Set
Point Display Text Panel?
To enter a new value, or change an existing value on the EZSeries
Set Point Display Text Panel, simply move the cursor (using the arrow
keys) to the message you want to edit. Once the cursor is on the
message, press the ENTER key on your EZSeries Set Point Display
Text Panel. This will move the cursor to the data set and allow you
to change the value. Once the value is changed, press the ENTER
key again to accept the new value and move the cursor back to the
beginning of the message.