EZ EZ-220, Hardware Manual

Page: 74 / 150

70
EZ-TEXT-M-E
Text Panel Hardware Manual
This register controls
LEDs and PLC Button
Release (Read Only or
Read/Write address)
message. See step 16 (next step) to program a PLC Message . To
program a Local Message , perform the following steps.
a. Next to Local Messages , click on the Add Local Folder button
or the Add Local Message Button.
b. Under Step 2 , type in up to 20 characters in the Message Text
fi eld.
c. Step 3 , click on the Press to Accept Message Edit button. The
message text you have typed in will appear in the Local Message
fi eld.
d. If you want to embed data from a PLC register in a Local Message,
place the cursor in the message where you want the value to appear
and press F5 or ( CTRL+1) for DATA 1, F6 or ( CTRL+2) for DATA
2, or F7 or ( CTRL+3) for DATA 3. Each press of the function key
will enter one data value digit. You may enter up to 5 characters
(depending on the data type).
In the message, the data will be represented by red 1’s for DATA
1, blue 2’s for DATA 2, and green 3’s for DATA 3. (The actual
value will display in the message on your EZSeries Set Point
Display Text Panel.)
e. Now you will need to confi gure the embedded data . If you have
embedded data, you will notice that the DATA 1, DATA 2, or DATA
3 fi eld is now available.
f. You must fi rst enter the PLC Address where the value resides.
Select the Data Type ( format) for your PLC Type (either BCD or
Binary ).
g. Select the Access for the PLC register. Will you want the message
to display a register value (READ only)? Do you want the message
to display a register value and allow the operator to change the
This register controls But-
tons and Panel Acknowl-
edge (must be READ/
WRITE address)