CHAPTER 73
PAGE 16
MAINTENANCE MANUAL EXTRA 300SC
PAGE DATE: 12. February 2019
13
Install rod end to mixture actuator with bolt, washers, castle
nut and cotter pin. Tighten the castle nut slightly. Ensure
movability of actuator.
14
Install the firewall forward cable ties on positions as marked
before.
15
Perform Mixture Vernier Control Cable Rigging.
Rigging
1
Move mixture control knob to the foremost position.
2
Check that the travel stop at the mixture actuator is reached,
and the over-travel of 5 mm [3/16"] (tol/-1 mm
[1/32"]) is ensured at the mixture control knob (see distance
"e" on Figure 7).
fwd
e
Figure 7
Over-travel at Mixture Control Unit
3
Check full travel.
4
If necessary adjust rod end (2, Figure 8) by the following
steps:
a
Remove cotter pin, castle nut, washers and bolt from the
rod end (2) to mixture actuator (3) attachment.
b
Loosen the counter nut and adjust rod end (2) by turning.
Ensure thread is visible in the inspection hole when fasten-
ing. Apply inspection lacquer on the counter nut.
c
Reconnect the rod end (2) to the mixture actuator (3).
Summary of Contents for 300/SC
