CHAPTER 51
PAGE 35
MAINTENANCE MANUAL EXTRA 300/SC
PAGE DATE: 12. February 2019
4
After cleaning, thoroughly dry all metal parts with filtered,
dry compressed air.
5
It is recommended that all O-rings, backup rings, and wip-
ers be replaced at each overhaul. However, if necessary, O-
rings may be reused, but should be put back into position
from which removed.
6
Wipe down O-rings, backup rings, wipers, or other rubber
parts with a clean dry cloth. Lubricate with a suitable O-ring
lubricant prior to installation.
Paint Removal
Disassemble components to the level required for repaint-
ing, then proceed as follows.
W A R N I N G
Stripping solvents can be toxic and volatile. Use only
in well ventilated areas. Avoid physical contact with
solvent and do not inhale vapors. Keep solvent contain-
ers covered when not in use.
N O T I C E
Before stripping parts, remove all fittings, O-rings,
nuts, bolts, washers, pistons, bearingcups, etc. Parts
must be totally immersed in solvent, to maximize clean-
ing.
1
Degrease part per degreasing paragraph.
2
Totally immerse part in paint removing solvent. Portions
not totally covered by solvent will begin to corrode.
N O T E
Stripping agents are commercially available for remov-
ing topcoat and primer. Follow manufacturer's recom-
mendations for use and disposal of stripping solutions.
3
Remove part from solvent and rinse thoroughly with water
heated to 160° to 180°F (71° to 82° C). Flush solvent from
all cavities and threaded holes where entrapment might oc-
cur
4
Thoroughly dry part with filtered, dry compressed air.
Aluminium and Steel Components Refinishing
REPAIRS
Summary of Contents for 300/SC
