background image

APEX V1 FOIL QUICK SET UP GUIDE

MAST

REAR WING

FUSELAGE

4x T30 28mm Custom Titanium Screws

 4x Titanium T-Nut Deck Washers 
(Supplied with Apex V1 board)

2x T30 **mm Custom Titanium screws  

2x T30 **mm Custom Titanium screws

2x T30 22mm Custom Titanium Screws 

2x T25 Custom Titanium Barrel Nuts 
(fixed inside the Fuselage) 

FRONT WING

2x T25 Custom Titanium 
Barrel Nuts
(Fixed inside the Fuselage)  

2x T30 Custom Titanium Barrel 
Nuts (Fixed inside the Mast)

BY REMOVING THIS DOCUMENT AND 

ASSEMBLING THIS PRODUCT YOU 

ARE AGREEING TO THE FOLLOWING 

TERMS AND CONDITIONS:

•  The user understands that use of this product and 

any of its components involves certain inherent 
risks, dangers and hazards that can result in serious 
injury and death.

•  The user has read, fully understands, and agrees 

to be bound by the terms of the Ozone product 
manual including the Release of Liability, Claim 
Waiver, Assumption of Risk Agreement, Warnings 
and Safety Precautions.

•  Any and all users of this product must fully 

understand and agree to these terms. 

IF YOU ARE UNWILLING TO BE BOUND BY THESE 
TERMS, KEEP THIS DOCUMENT IN TACT AND RETURN 
THIS PRODUCT (BEFORE USE) FOR A FULL REFUND.

IMPORTANT NOTES:

•  Before assembling check all connecting surfaces, screws and barrel nuts are 

clean and free of sand, salt or other debris.

•  Only use original Ozone screws and barrel nuts. Damage and/or loss may occur 

if using another type of screw.

•  Do not tighten screws until all screws are in position and correctly threaded.
•  Do not over tighten the screws, firmly hand tighten (approx. 8N.m torque 

wrench setting) and release screws by hand only. Do not use power tools.

•  The Fuselage barrel nuts are glued in place. These have a T25 head so the 

supplied T30 tool cannot be used to mistakenly tighten or loosen. Do not 
tighten or loosen the Fuselage barrel nuts, only tighten or loosen the screw. 
If a Fuselage barrel nut becomes loose, use standard super glue to fix it back 
into place.

•  The Mast barrel nuts are glued in place. These have a T30 head so the supplied 

T30 tool can be used to rotate the nuts to align with the screws if necessary. If a 
Mast barrel nut becomes loose, use standard super glue to fix it back into place.

•  The Fuselage to Mast connection is designed to be a tight fit. Align the screws, 

get them started and proceed to tighten. Approximately the last 2mm of Mast 
tuttle section will be pulled into the Fuselage by tightening the screws. The 
connection will then become flush.

•  If stored set up, before each use check the screws and parts are fitting tight, 

retighten screws if necessary.

**Refer to the screw pocket inside the wing cover OR online manual for screw length)

VIEW ONLINE MANUAL

Reviews: