Extech Instruments 7630, Operation Manual

Page: 96 / 120

90
must substitute a value for the enclosed parameter. The Pipe ( | ) is used to separate different
parameter options for a command. Do not include any of the above characters when sending
the commands. The command and the value should be separated with a space.
All commands that end with a question mark (?) are query commands and required an
IEEE-488 read command to retrieve the data from the device's output buffer.
SETTING COMMAND DESCRIPTION COMMAND RUN TCT
TEST TEST
◎ ◎
RESET RESET
◎ ◎
HARD COPY Testing data TD?
◎ ◎
mode,state,meter1,2,3…
◎ ◎
STEP RESULTS nn nn=Step number,nn=1~30 RD nn?
◎ ◎
Result Memory (Memory link
enable) xx=File nn=Step number,xx =1~30,nn
min=1~30;
RD xx,nn? ◎ ◎
Read Scanner port status?
0=None
1=Internal(X)
2=External
3=Both internal and External(X)
RS?
◎ ◎
FILE:LOAD nn nn=01-50 FL nn
◎ ◎
FILE:NEW nn,xxx nn=01-50,xxx=name FN nn,xxxx ◎ ◎
LIST:FILE NAME? work file now LF? ◎ ◎
LIST:FILE NAME nn? LF nn?
◎ ◎
FILE:DELETE work file now FD
◎ ◎
FILE:DELETE nn nn=01-50 FD nn ◎ ◎
FILE:SAVE
work file now (The file number must
be bigger than 0.)
FS
◎ ◎
FILE:SAVEAS nn,xxx nn=01-50,xxx=name FSA nn,xxxx
◎ ◎
File memory link enable
Files memory link enable. (Step should
be 30 steps, and not last files.)
FME
◎ ◎
Files memory link disable. FMD ◎ ◎
File Momory state.1=enable 0=disable. FM? ◎ ◎
STEP:SELECT nn nn=01-30 SS nn
◎ ◎
STEP:SELECT? nn=01-30 SS?
◎ ◎
STEP:ADD:RUN
(The file number must be bigger than
0.)
SAR
◎
STEP:ADD:TCT
(The file number must be bigger than
0.)
SAL
◎
STEP:DELETE work STEP now SD
◎ ◎
STEP:DELETE nn nn=01-30 SD nn
◎ ◎
STEP:PROMPT clr prompt SP ◎ ◎
STEP:PROMPT xxxxxx xxxx=word SP xxxxx
◎ ◎
LIST:PROMPT? work STEP now LP?
◎ ◎
LIST:PROMPT nn? LP nn?
◎ ◎
LIST:STEP? work STEP now LS? ◎ ◎
LIST:STEP nn? LS nn?
◎ ◎
Example: 1,RUN,600.0,0.0,10.00,0.00,0.5,0.5,0.00,0.00,1000,00,1.000,0.000,ON
State :STEP number,Type,Voltage-HI,Voltage-LO,Amp-HI,Amp-LO,Delay,Dwell,Leakage-HI,
Leakage-LO,Power-HI,Power-LO,PF-HI,PF-LO,Continuous,Mn
◎