Eurotherm 637+/D6R KD6R, Product Manual

Page: 64 / 87

64
Product-manual Model: 637+/D6R KD6R 07-02-09-01-E-V0402.doc
Diagnosis and trouble shooting
7-segment display
display explanation output
ready output
2)
warning
Comment
overvoltage on
DC bus 1) 1) ballast module ok?
adequate ballast module?
chassis shorting and
short circuit due to
hardware
off off
motor cabling ok?
digital-loops setup ok?
short circuit to chassis in the motor? braking
resistor: ohm- value too low? try to start fresh!
send in for repair
*
WARNING!
overload of the
regulator I²t or motor
I²t or temp.-output
stage too high.
If no reaction within
approx. 3sec.it
switches off with
signals /3/, /4/ or /5/.
Signal /8/ clears when
there is no more
danger or it is
switched off
off 1)
mechanics stiff?
defective bearings;
cold grease?
reduce requirements and creep to next possible
STOP
overtemperature
motor(NTC/PTC) off check overload of the motor / cooling etc.
*
motor temperature
too high on 1) check overload of the motor / cooling etc.
ballast active
Brake energy is removed
warning I²t ballast
too high on 1) ballast resistance
usage >90%
switch off
ballast on 1) ballast resistance overloaded
X 300 – Modul
not inserted
or wrong inserted
or defect off off X 300 testing
Chapter1.4.3.1 Layout
X 300 – setting
wrong
off off X 30 / X40 Counter-Configuration test in
the EASYRIDER

Windows – Software
*
tracking window
exceeded only in operation mode position control, will be
deleted with the next run-command
tracking error
with switch off only in operation mode "position control"
memory-checksum-
error off off try new start
1) Reaction to these errors see chapter 3.3
2) With configuration corresponding chapter 3.1
* Only warning respect. status indicator
The error signals are shown as long as there is control voltage (Us), also when the power (DC-Bus)
is switched off for safety reasons.