Know
WinClient
PCN-1001 User manual
75
Pay attention to the following issues:
•
Exclude as much as possible the area outside the transportation vehicle
•
Verify that all the entrance area is detected properly. Make a person move under the PCN-1001s and
verify the correct detection
•
The PCN-1001 can’t track more than 10
people at a time. In particularly crowded
conditions, i.e. on-board buses, 10 people
can
be compressed in less than 1 m
2
, so the
detection area should be smaller. In these
conditions a depth of 70~90 cm at floor
level is fine to guarantee a good tracking of
people.
“Single Way Tracking” panel
If this option is flagged, tracking will only work when people passing under the Counter are moving in one
direction. Tracking will not work when people are moving in two directions at the same time.
“PCN-1001 System diagnostic” panel
Note:
With the WinClient software revision 2.2 the “PCN-1001 System diagnostic” works only if the PCN-1001 is
set in single configuration.
This is a diagnostic algorithm that detects and signals any problem that may occur to the optical section of the
PCN-1001 (i.e.: blind cameras, cameras malfunction, luminosity too low, etc.).
Pressing the “Get Status” button will change the colour of the grey circle:
•
If the circle is red the diagnose is negative (there is a problem)
•
If the circle is green the diagnose is positive (no problems occurred)
Every time the diagnostic status changes, it will be written on the log file
Suggested depth:
70~90 cm
Summary of Contents for PCN-1001
