Eurotech PCN-1001, User Manual

Page: 91 / 118

Test
an RS485 connection and use the RS485_GUI PCN-1001 User manual
91
PCN-1001_UserMan_En_4.0
Commands availability
These commands are incorporated in the SNP (Small Network Protocol) protocol.
COMMAND
DESCRIPTION
address Sets the PCN-1001 IP address
autoled
Enable the automatic regulation of the LED indicators
diagnostic_en Enables or disables the diagnostic
enable_pc Enables or disables the counting process
fw_version
Reads the version number of PCN-1001 FPGA firmware
gcounters Returns the values of the Incoming and Outgoing counters
gdatetime Reads the date and the time
input0 / input1 Sets the functions of the two input lines
ker_version Reads the version number of PCN-1001 kernel
output0/output1 Sets the optocoupled outputs open time
pcn1001_status Returns the PCN-1001 diagnostic status
reset
Resets the Incoming and Outgoing counters
sdatetime Sets Date and Time information
sled Sets the LED intensity
sys_version
Reads the version number of PCN-1001 operating system
version
Reads the version number of PCN-1001 core software
address
Command address
Command Description Sets the IP address of the PCN-1001
Parameters
String
Parameters Description
String containing the IP address (e.g.: “10.100.10.100)
Returns
autoled
Command autoled
Command Description Enable the automatic regulation of the LEDs.
This regulation is based on the luminosity of acquired images
If the automatic regulation is activated the manual control (sled
command) will be ignored.
Parameters Unsigned char (1 byte)
Parameters Description 0: Disabled
1: Enabled
Returns
diagnostic_en
Command
diagnostic_en
Command Description Enables or disables the diagnostic
Parameters Unsigned char (1 byte)
Parameters Description
0: Disabled
1: Enabled
Returns