Eurotech PCN-1001, User Manual

Page: 62 / 118

Know WinClient PCN-1001 User manual
62
PCN-1001_UserMan_En_4.0
For installations within buildings:
In these kinds of installation, it is assumed that the environment has a constant illumination.
The right light intensity has to be found experimentally.
For on-board installations:
Slide the bar completely to the right, and put the light intensity to the maximum.
This will increase the counting accuracy even in installations where the environmental lighting conditions are
always changing and can vary suddenly.
The “In/Out direction” panel
Be careful to set the direction for incoming and outgoing people in the right way, paying attention that the arrows
refer to the motion of people as displayed on the WinClient interface.
Changing the direction will reset the in/out counters.
The “Door kind” panel
When, on-board a transportation vehicle, a door is dedicated to the entering only or the exiting only of
passengers, this option allows the explicit declaration of the kind of door.
This declaration does not disable the income counting in a door declared as “one-way out” but decrease the
erroneous counting of incoming people due to reflections or due to atypical behaviour of passengers (a
passenger that was intended to go out, invert his direction and returns back) in the proximity of the open door.
The “Door threshold” panel
This is an important parameter that has to be properly set to obtain a reliable counting process.
During the tracking process, the two counters are incremented only if a person enters the detection area, crosses
the door threshold and then exits from the detection area on the opposite side.
By default, the threshold is placed at row 60 (the image height is 120 rows). The position of the threshold line can
be set between row 30 and row 89.
In each visualization mode, except for “Tracking”, flagging the “View Threshold” checkbox will display the current
threshold (a white horizontal line) in Windows 1 and 2.
Threshold