15
Prodigy FlyPipe Installation Guide
Chapter 5
Terminate Lift Lines to the Drum
Perform the following steps to terminate your lift lines to the drum of your FlyPipe.
CAUTION:
Before terminating each set of TwinLine lift lines to the drum,
ensure there are no twists at any point in the run and that the lines are
plumb.
Step 1: Verify the Drum is At Top Dead Center
The drum is at top dead center when the two holes in the drum are visible from the cutouts
where the SafeStop devices rest. This is the position of the drum when it is shipped and is the
position required to thread the lift lines through the drum.
Step 2: Thread Lift Lines Through SafeStop and Drum
1. Thread the lift lines down through the two holes on the top of the SafeStop
device and through the sheave near the bottom.
2. Pull the lift lines out the bottom of the device and run them through the
hoist. With the drum at top dead center, the two holes in the drum should
be visible from the cutout where the SafeStop device was resting.
