17
Prodigy FlyPipe Installation Guide
228 mm (9 in)
5. Cut the wire rope a couple feet past the marks that you just made.
6. Slide a 1/8 inch stopper sleeve on to each wire rope. Crimp each stop sleeve on the same
side of the marks you made. This should be done using the J groove on your Nicopress
swaging tool.
7. Gauge the crimp with the Nicopress Go-Gauge to ensure proper crimping.
8. Trim the excess wire rope as close to 3 mm (1/8 in) from the bottom of the stopper sleeve
as possible.
CAUTION:
Wire ropes that are trimmed longer than 4.5 mm (3/16 in) from
the bottom of the stopper sleeve can cause damage to the hoist.
Step 4: Finalize Lift Line Termination
1. From above the hoist, pull the lift line closer to the motor up through the hoist until the
stopper sleeve seats into the deeper of the two recessed grooves in the drum.
2. Pull the second lift line up through the hoist until the stopper sleeve seats into the shallow
recessed groove in the drum.
1
2
