Open the users menu and go to service menu. If the
access is protected enter the password and confirm with
OK.button.
SENSOR CONFIGURATING:
After completing adding of the sensors you have to configure them. Each sensor can be set with:
measurement calibration
two temperature alarm levelss (MIN and MAX)
name
door opening alarm
Then go to section Sensors take option Edition and
press OK...
List of connected sensors will appear. Chose a sensor to
configure and press OK...
All sensors parameters will be displayed.
Chose a parameter to configure and press OK..
when the value of measured temperature is
different than real value you can calibrate the temperature
sensor. Parameter value is added to the measured value.
Value range: 10.0...+10.0°C
minimal temperature level. If the
temperature reaches this level, the recorder will activate
buzz alarm and an alarm will be displayed.
Alarms will be saved in the
memory and marked on the printout. Setting range:
maximum temperature level. If the
temperature reaches this level, the recorder will activate
buzz alarm and an alarm will be displayed. Alarms will be
saved in the memory and marked on the printout. Setting
range: 50.0...+99.9°C
users description e.g. Rear sensor, fridge etc.
Using up/down chose a character
Using OK. edit next character.
Using Menu edit previous character
Save description by pressing OK.. for 3 seconds
wireless sensor is equipped with door
opening sensor. Connect door sensor to logical input D1
with cables as in paragraph 5.4 and chose a circuit type:
NO (normally opened) alarm after closing D1
NC (normally closed) alarm after opening D1
NO door sensor deactivated
17