CONSTRUCTION:
BATTERY REPLACEMENT (if the red LED flashes every 60 sec.):
B
A
C
D
E
F
CONNECTION:
Notes for D1:
polarity of wires
does not matter
female connectors 2.8 x 0.8 mm
use a twocore cable
with a crosssection of min. 0,5 mm2
and length up to 30m
Notes for T2:
polarity is important
sensor cable with a length of 10mb
extension allowed up to 20mb
using a cable with screen and
26AWG section
A
builtin temperature sensor
B
additional temperature probe
on a cable with a length of 10m
C
radio antenna
D
1
hermetic housing
with room for battery
and wire connectors
E
signaling diodes on the board:
unscrew 4 screws and
remove the housing cover
COM (green):
radio communication
BAT(red):
low battery
SIGNALING OF DIODES:
every 60 sec. blinks once
(communication OK)
every 60 sec. blinks twice
(communication lost)
blinks once at startup
after inserting the battery
every 60 sec. blinks once
(low battery voltage)
blinks once at startup
after inserting the battery
DESCRIPTION:
ted
Each wireless sensor has
a builtin temperature probe.
Additionally, it has the
possibility of connecting the door opening signaling sensor and the second temperature probe on
The recorder has 4 temperature measurement channels and 4 signaling channels for door opening
operation. Temperature sensors are connec
to the recorder wirelessly.
2
mount a new battery in the holder,
paying attention to the correct one
polarity (the negative pole is on
the side of the antenna)
3
screw in again, solidly
4 screws on the housing cover
F
mounting brackets
8
