Run users menu and go to the service menu. If the
access to the menu is protected enter a password and
confirm pressing OK..
ADDING SENSORS:
Recorder has 4 measuring channels. It can operate with 4 temperature sensors,no matter they
are wireless sensors or additional cable probes. You can pair the device with 4 independent
wireless
sensors or or e.g. 2 wireless sensors and 2 additional cable probes.. Before pairing the sensors
with the recorder, run the sensors and connect them accordingly to paragraph 5.4 then follow the
Sensor will not be visible in radio network, if it ever has been previously paired
with
another recorder. To pair the sensor with a new device, please remove the battery out of
the
sensor
Go to Sensors section, then Add and start searching
sensors in the network with a buttonOK Searching lasts
around 1 minute and it is signalled by following message:
After completing the recorder will display a list of all
available sensors. Example on the left.
Check the sensors number and choose the one you want
to add by pressing
.
If it is wireless sensor with data stored in the cache
memory, the following message will appear:
Confirm with OKor cancel the download of
uneccesaryprevious data with
button.
After adding a sensor the device will go back to the list of
sensors. Add another sensor and follow the process as
above or exit the add list using menu button.
Each wireless sensor has an unique
identification adress, which can be found on the
label.
Cable probe has a number similar to wireless
sensor to which its connected. (First three
numbers are the same, last one is higher by one
value .
Address:
15B3
Sensors adress:
Measurement Range Battery Adress
If the sensor you would like to add is not on the list
please check the battery, diod signalisation, cable
probe connection or possibly reset the sensor by
removing a battery for 3 minutes. Try to restart
searching.
After adding 4 sensors, following message will appear:
Exit sensor adding function with
button
16
