Epson TM-930II Series, Operator'S Manual

Page: 38 / 89

5-3
Printing on Slip Paper and Notes
n
Printing on slip paper
Use the following procedure to start printing on the slip paper.
User Operation
1 Transmit
“ESC f
m n"
2 Transmit
“ESC
C
0 n”
NOTES:
3 Insert paper.
4 Transmit data and
commands.
5 Transmit “FF”
Printer
Operation
Sets the internal timer for set-up time (m) and (n).
Printer switches to slip mode and waits for slip
paperper to be loaded (waits the set-up time set by
ESC f
m n).
Blinks the slip LED.
After detecting the paper, lights the slip LED,
redetects the paper after set-up time (n) has
passed, then feeds the slip
paper to the printing
start position. If the paper is not detected after set-
up time (n) has passed, the printer returns to the
paper waiting state. If the paper is not inserted
during se-up time (m), the printer cancels the slip
mode and goes to P-sheet mode.
Prints the data and feeds the paper.
After printing, ejects the paper and switches to 2-
sheet mode.
Tums off the slip LED.
1. Ejecting is performed in the forward direction only.
2. Since the paper feed pitch is inaccurate directly after the paper feed direction
has been changed, special attention should be paid to the printing thereafter.
3. The mechanical structure allows the paper to feed only when the roll paper is
loaded properly. Accordingly, roll paper must be loaded onto both the receipt
and journal sides before selecting slip paper printing by
ESC c 0 n.
4. In the slip paper waiting state, all the panel switches and the cover open de-
tectors are disabled.
5. When successive printing is executed on slip paper, the paper insertion interval
should be set to more than 10 seconds to limit the mechanical duty.
6. Slip paper should be set correctly by matching the top edge with the from
stopper and the right-side with the right-side of the paper insertion position.
7. After executing FF (Form Feed), the printer switches to P-sheet mode with the
cut sheet left in the printable area. Therefore, before receiving print data, the
cut sheet must be removed within the time required for switching to P-sheet
mode (approx. 2 seconds) to prevent the next data from being printed on the
cut sheet form.
32