Epson Stylus Color 760, Service Manual

Page: 91 / 172

EPSON Stylus COLOR 760 Revision C
Disassembly and Assembly Disassembly Procedures 91
4.2.4.5 Removing the ASF Assembly
1. Remove the Upper Housing. (Refer to Section 4.2.1.)
2) Remove the following Cables from the cable hook on right side (viewed
from back side) of the ASF Assembly.
- ASF HP Sensor Cable
- PF Motor Cable
3) Remove two screws (No.7 and ASF fixing screw) securing the ASF unit on
the Bottom Frame. Refer to Figure 4-19.
Figure 4-19. Removing the ASF Assembly (1)
4) Release the hook fixing the Gear 27.2 to the ASF LD Shaft on the left of
the ASF Assembly (Viewed front) and slide it left little carefully. Refer to
Figure 4-20.
NOTE: Do not damage the Loop Scale when sliding the Gear 27.2 to the left. In
case the Gear 27.2 is removed in above step 4, the Loop Scale may be
damaged with the Gear 27.2.
Figure 4-20. Releasing hook for the Gear 27.
5) Slide the ASF unit to the right side (viewed from back side) and pull it
backward carefully while holding the Sub Paper Support Upper upward.
Refer to the Figure 4-21.
Figure 4-21. Removing the ASF Assembly (2)
No.7 Screw
ASF Fixing Screw
Bottom Frame
Hook for Gear 27.2
Gear 27.2
Sub Paper Support Upper
Step1
Step2