Epson Stylus Color 760, Service Manual

Page: 83 / 172

EPSON Stylus COLOR 760 Revision C
Disassembly and Assembly Disassembly Procedures 83
4.2.4.1 Removing the Printhead Unit
1. Remove the Upper Housing. (Refer to Section 4.2.1.)
2) Slide the CR Lock Lever to the front using tweezers or small driver and
release the CR Lock Lever from the CR unit. Then move the CR Assembly
to the left.
3) Take both black and color ink cartridges out of the CR Assembly.
4) Remove the blue covers for black and color ink cartridges from the CR
Assembly.
5) Remove the Torsion Spring 49 from the left side of the CR Assembly and
one screw (No.2) securing the Fastener Head Plate.
Then take out the Fastener Head Plate. Refer to the Figure 4-7.
6) Remove the Head FFC Holder from the CR unit by releasing four hooks.
(Two hooks; Left/Right sides of CR unit, Two hooks; Back sides of CR unit)
Refer to Figure 4-7.
Figure 4-7. Removing the Printhead
7) Remove the two Head FFC being connected to the Printhead Drive Circuit
Board built in the CR unit and remove the narrow FFC from the CR
Encoder Sensor Board on the CR Assembly.
Fastener Head
Plate
Head FFC
Holder
One Hook for Head
FFC Holder
Torsion Spring 49
One Hook for
Head FFC Holder
No.2 Screw
Two Hooks for
Head FFC Holder