Epson Stylus Color 760, Service Manual

Page: 146 / 172

EPSON Stylus COLOR 760 Revision C
Maintenance Overview 146
16
<Lubrication Point>
Oil pad in the carriage assembly Lubricate the oil pad only when:
• Replacing the carriage
assembly
• Replacing the oil pad
Use a precise syringe to apply oil.
If you accidentally apply too
much oil to the oil pad, throw the
pad away and take a new one
again.
Leave the pad for a while to wait
until oil is evenly infiltrated, then
install it on the carriage
assembly.
<Lubricant Type> O-12
<Lubrication Amount>
0.72 ~ 0.77cc (0.65 ~ 0.69g)
Note:
This is the amount to be applied to a new
oil pad.
17
<Lubrication Point>
Shaft for “FRAME, LEFT”
See Page 150. <Lubricant Type> G-26
<Lubrication Amount>
φ
1 x 5mm
18
<Lubrication Point>
Inside of the right hole of “FRAME, ASF;
B”
Apply grease evenly to the inside
of the hole.
Use a brush to apply grease.
See Page 150.
<Lubricant Type> G-26
<Lubrication Amount>
φ
1 x 1mm
19
<Lubrication Point>
Left and right edges of “HOPPER
ASSEMBLY; C”
Use a brush to apply grease.
See Page 151.
<Lubricant Type> G-26
<Lubrication Amount>
2mm-diameter ball
Table 6-2. Lubrication Point (continued)
No. Standard Remarks / Reference Page
20
<Lubrication Point>
“GUIDE PLATE, CR” (the part where the
carriage slides on.)
See Page 151.
<Lubricant Type> G-26
<Lubrication Amount>
φ
1 x approx. 270mm
Table 6-2. Lubrication Point (continued)
No. Standard Remarks / Reference Page