Epson PowerLite 735c, User Manual

Page: 35 / 144

Presenting Through a Wireless Network
29
Configuring the Connection
You can use NS Connection to connect to the projector and send
images wirelessly in two modes: Ad Hoc mode or Access Point mode.
■
Ad Hoc mode lets you connect just one PC or laptop to the
projector at a time; it’s easy to set up, and the only equipment you
need is a computer with a wireless (802.11b) network card.
■
Access Point mode (or “infrastructure” mode) is more complex to
set up, but lets multiple users access the projector at the same time
and easily trade off control over the projector. To use Access Point
mode, you need a wireless (802.11b) access point and one or more
computers with built-in wireless network cards.
Follow the correct instructions below for the mode you want to use.
Using Ad Hoc Mode
In order to use Ad Hoc mode, first adjust your projector and network
card settings as described in this section.
Configuring the Projector
To configure the projector for Ad Hoc mode, make sure you’ve
switched it to EasyMP and inserted the network card (see page 28).
Then follow these steps:
1. On the EasyMP Network Screen, the
Config
button is already
highlighted as shown below.
2. To select
Config
, press the
Enter
button on the remote control.
note
Make sure you’ve installed
the NS Connection software
as described in Appendix A
or the Quick Setup sheet.
Config button