Control Panel Buttons and Lights
Pitch (Font) button**
Selects a pitch and font.
*Micro Adjust mode
When you hold down the Pause button for three
seconds, the printer enters the micro adjust mode. In this
mode, you can press the LF/FF
D
and Load/Eject
U
buttons to adjust the top-of-form or tear-off position. See
Chapter 2, “Using the Printer.”
**Font select
In the Micro Adjust mode, you can select the font to use
for printing by pressing the Tear Off button. The Tear Off
lights turn on, off or flash to indicate the selected font.
Pause button
Stops printing
temporarily, and
resumes printing when
pressed again. When
pressed for three
seconds, turns on the
Micro Adjust mode*. To
turn off, press again.
Pause light
●
On when the printer
is paused.
●
Flashes when the
printer is in the Micro
Adjust mode*.
●
Flashes when the
print head has
overheated.
Paper Out light
●
On when no paper
is loaded in the
selected paper
source or when
paper is not
loaded correctly.
●
Flashes when
paper has not
been fully ejected
or a paper jam has
occurred.
LF/FF button
●
Feeds paper line
by line when
pressed and
released.
●
Ejects a single
sheet or advances
continuous paper
to the next top-of-
form position
when held down.
Load/Eject button
●
Loads a single sheet
of paper.
●
Ejects a single sheet
of paper if a sheet is
loaded.
●
Loads continuous
paper from the
standby position.
●
Feeds continuous
paper backwards to
the standby position.
Tear Off (Pitch/Font) lights**
Flash when continuous paper is in the
tear-off position; otherwise, the lights
indicate the selected font.
Summary of Contents for LQ-1150 II
