Epson Fast T-Jet 3 PLUS, User Manual

Page: 19 / 135

Chapter 2 - Unpacking and Setup
9
2 – Chip Blocks / 2 Chip Block Supports •
1 – Cartridge Removal Tool •
8 – Ink Cartridge Caps (for cartridge storage) •
16 – Ink Line Caps •
1 – Syringe •
1 - Latex gloves •
Waste Ink Bottle
Waste Ink Bottle •
Secure Nut and Ink Line Fitting •
Waste Bottle Shelf Bracket •
Exhaust Fan
1 - Split power cord •
Lifting Your T-Jet3 PLUS Unit From the Box
WARNING! DO NOT lift alone. Lift with your legs, not your back!
Lift from SIDES ONLY
With an assistant, lift your T-Jet3 PLUS from
the box and place it on a fi rm, level surface
that supports the entire printer base
including the Print Bed. If any part of the
T-Jet3 PLUS base is hanging over the edge
or not supported in this manner, stress will
be placed on the Print Bed causing poor
functionality . For best results place the unit
on a table with extra room for a computer,
replacement ink and a Workspace.
Preparations
Remove Hold Down Clamps
With a Phillips head screwdriver, loosen the four Bed Holder
Brackets located toward the bottom of each side of the
Print Bed. You must remove these, but replace the screws to