Epson Fast T-Jet 3 PLUS, User Manual

Page: 85 / 135

Chapter 6 - Printing on Other Items
75
Now that the total print area has been set, you must now determine the location
for each individual image that will be printed.
Using the fi rst non-textile item that is closest 4.
to the upper left hand corner of the print
bed, measure from the left side of the print
bed to the center point where the image is
to be located (X axis). Fractions of an inch
matter, so be precise.
For reference:
1/8 = .13 1/4 = .25 3/8 = .38
1/2 = .50 5/8 = .63 3/4 = .75
7/8 = .88
Using the same item, measure from the top 5.
of the print bed down to the bottom point
where the image should stop on the non-textile
item (Y axis). The red dotted line identi fi es the
measurement taken for the bottom of the logo.
Steps 4 and 5 will give you the location in which to position the fi rst image. 6.
Using the rulers framing the FastARTIST workspace, place the image in the
proper location. You may also type in the desired location in the X/Y boxes
with the image selected.
Repeat steps 4, 5 and 6 for each of the remaining items. We recommend
measuring items starting in the upper left hand corner and moving left to right
and from top to bottom.
Setting up FastRIP
Once the Print command is given, FastRIP will open and proceed to spool the
print job.
Upper Left-hand Corner Upp Upper er Lef Left-h t-hand and Co Corne rnerr
Logo
o o p pos osititio ionn th the e fifi rs rstt im imag age e
Logo