Epson Fast T-Jet 3 PLUS, User Manual

Page: 20 / 135

T-Jet3 PLUS User’s Manual
Version 1.1 Revised July, 2008
10
maintain machine integrity. Move the Print Bed back and forth to ensure smooth
movement and then return the Print Bed to its Eject position.
The Maximum Height Bar
You have received a metal bar with a magnetic strip attached to one side.
Place this bar under the chrome T-Jet logo on the front of the printer. This bar
will act as a simple head strike warning device. At NO time should a garment or
other item to be imprinted sit high enough on the Shirtboard to make contact
with this bar. If a garment would brush against this bar, there is an imminent
danger of a collision with the Print Head. A head strike could permanently
damage the Print Head, resulting in down time and costly repairs.
Use this Bar as a reference for loaded garments, adjusting the
Shirtboards etc., but remove before printing .
Check the Adjustable Shirtboard Height
Place an adjustable Shirtboard within the Print Bed and use the adjustment knob
to raise or lower its surface to the proper height.
WARNING: WARNING:
Use the Maximum Height Bar as your guide to prevent
Print Head strikes. The adjustable
Shirtboard should be raised to a
level where the printable surface of
the garment is as close to the Bar
as possible, but DOES NOT make
contact with the Bar at any point. The Shirtboard
MUST NOT be raised beyond this point!
:HDUH
not responsible for any damage
caused by disregarding Maximum Height
warnings. Replacement of Print Heads is NOT
covered by your warranty.