Troubleshooting
112
Check
Remedy
Are signals being received within the Wire-
lessHD transmission range?
Check the Wireless HD transmission range, and view within that
range.
s
Is the supplied WirelessHD Transmitter
turned on?
Check the
t
indicator on the WirelessHD Transmitter. If there is
no power being supplied, make sure the connector for the AC
adapter is securely connected, and then turn on the power
switch.
Is the WiHD indicator for the supplied Wire-
lessHD Transmitter off?
No signal is output from the AV device connected to the Wire-
lessHD Transmitter. Check that the cables from the AV device and
the WirelessHD Transmitter are securely connected.
Images are being output from a monitor device, such as a tele-
vision, connected to the Output port on the WirelessHD Trans-
mitter. Press the
button and change the output image
to the projector.
Is the Link indicator for the supplied Wire-
lessHD Transmitter off?
The WirelessHD cannot communicate with the projector. Check
the Wireless HD transmission range, and view within that range.
Has dust collected in the WirelessHD's air in-
take vent?
If the WirelessHD receiver becomes hot, it may not receive sig-
nals. Clean the dust so that heat can be vented.
Are the projector and the WirelessHD Trans-
mitter facing the correct way?
Setup the projector and the WirelessHD Transmitter so that they
are facing each other.
Is
"Source: WirelessHD X"
/
"No Signal"
dis-
played in the lower-left part of the screen?
Check that the AV device connected with the HDMI port on the
WirelessHD Transmitter is turned on. The input signal number
displayed on the screen is the same as the HDMI port number.
In addition, unless
HDMI Link
is set to
On
, the connected device
does not turn on. Set
HDMI Link
to
On
.
s
Settings
-
HDMI
Link
-
HDMI Link
Interference, distortion, or interruption appear in WirelessHD
Check
Remedy
Are signals being received within the Wire-
lessHD transmission range?
Check the Wireless HD transmission range, and view within that
range.
s
Are there any obstructions between the Wire-
lessHD Transmitter and the projector?
Because WirelessHD communicates using a tight beamed elec-
tromagnetic wave, if there are any people or objects and so on
obstructing the communication path, this could have an adverse
affect on the image. Make sure that there are no obstacles be-
tween the WirelessHD Transmitter and the projector within the
WirelessHD transmission range.
s
Is the reception too low?
If the transmissions are not strong enough, communication may
be unstable.
Check
Reception
while images are being projected as you set
up the transmitter as it is sometimes possible to improve the
strength of the transmission by moving the WirelessHD Trans-
mitter or changing its direction.
s
Settings
-
WirelessHD
-
Reception
Transmission strength may differ depending on the surround-
ings, or they may be unstable. While checking
Reception
, setup
the transmitter in a location where the number displayed re-
mains steady.
s
Settings
-
WirelessHD
-
Reception
