7.
Hold the connector on the IDE device cable so the red wire
aligns with pin 1 on the drive. Make sure the holes in the
connector fit over all the pins; then push in the connector.
8.
Locate a power supply cable for each drive installed in the
rear internal bracket. These cables lead from the power
supply and have multicolored wires with a plastic connector
on the end. Align the notched corners of the power supply
connector with the drive’s power connector; then push in the
connector.
Note
Your system has five power supply cables; three with large
connectors and two with small connectors. If you need more
than five cables, you can purchase Y-adapters at most
computer accessory stores. Y-adapters let you use one power
supply cable for two devices.
5-18 Installing and Removing Tower Drives
