Epson 2200 - Stylus Photo Color Inkjet Printer, Service Manual

Page: 152 / 258

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 152
4.2.9 Removing the Carriage Guide Shaft A and Carriage Unit
1. Remove the Printer Mechanism. (Refer to 4.2.1.4.)
2. Remove the Printer Head. (Refer to 4.2.7.)
3. Remove the Extension Spring 1.494 hitched on the left side of the CR Linear Scale
as seen from the printer front.
4. Remove the right side of the CR Linear Scale as viewed from the printer front.
5. Remove the left side of the CR Linear Scale as viewed from the printer front by
turning it 90
° (either upward or downward).
Figure 4-72. Removing the CR Linear Scale
A D J U S T M E N T
R E Q U I R E D
"
When changing or removing the Carriage Guide Shaft B, make
the following adjustment.
•
PG adjustment
"
After changing the following parts for new ones, always apply
grease G-26 or G-56 in the specified positions.
•
Sub Left Adjust Parallelism Bush:
Refer to Chapter 6, Figure 6-19, "Lubrication Point 21".
• Sub Right Adjust Parallelism Bush:
Refer to Chapter 6, Figure 6-20, "Lubrication Point 22".
• Carriage Guide Shaft B:
Refer to Chapter 6, Figure 6-21, "Lubrication Point 23".
C A U T I O N
Be fully careful when removing the Extension Spring 1.494 since
pulling it more than necessary will elongate the Spring.
Refer to Figure 4-72, "Removing the CR Linear Scale".
C H E C K
P O I N T
The Extension Spring 1.494 does not drop if it is removed from the
left hook.
Refer to Figure 4-72, "Removing the CR Linear Scale".
Hook
Hook
CR Linear Scale
Extension Spring
1.494
Hook