Epson 2200 - Stylus Photo Color Inkjet Printer, Service Manual

Page: 169 / 258

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 169
8. Remove the two screws 13) C.P.S 3
×
6 (6
±
1kgf.cm) that secure the CR Motor, and
remove the CR Motor from the Upper Frame.
Figure 4-107. Removing the CR Motor
"
When reinstalling the CR Motor, face the label of the CR Motor
rightward as seen from the printer rear.
Refer to Figure 4-108, "Installing the CR Motor".
Figure 4-108. Installing the CR Motor
"
After installing the CR Motor, fully use care not to damage the
tooth surface of the Pinion Gear.
Refer to Figure 4-107, "Removing the CR Motor".
C.P.S 3
×
6
CR Motor
Label
"
When changing the CR Motor, make sure that the Ferrite Core
is fitted to the Cable securely.
Figure 4-109. Checking the Ferrite Core
A D J U S T M E N T
R E Q U I R E D
"
When changing the CR Motor, the following adjustments are
necessary. Make the adjustments in the following order.
1.
CR tooth skip prevention mechanism adjustment
2. CR motor drive torque dispersion measurement
(maximum correction value input)
"
Refer to "Chapter 5 Adjustment" for the adjustment
procedures.
Ferrite Core