so it won’t be forgotten. Please connect the blower as shown below. The blower can be
purchased from Grainger’s (stock # 7C183).
1)
2)
Locate the exhaust port connector in the accessory kit. It‘s a round port with a square
flange, painted the same color as the base of the machine. On the rear of the machine,
locate the four screws around the port. Remove them, place the exhaust connector so the
screw holes align, and replace the four screws.
Using hose clamps, connect the supplied 4” flex hose to the exhaust port, and then to the
exhaust system.
CONFIGURE YOUR COMPUTER
Included in the accessories kit is a 3.5 inch diskette labeled EPILOG. With the computer
turned on and Windows open, insert the diskette into your 3.5 inch disk drive to install the print
driver. Your computer must have Windows 95 or Windows 98 already installed.
INSTALLING THE EPILOG RADIUS PRINT DRIVER
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
14)
Click on the “START” button at the bottom left of your screen.
Click on “SETTINGS”.
Click on “PRINTERS”.
Double Click on “ADD PRINTER”.
In the ADD PRINTER WIZARD click on “Next”.
Normally you should select “Local Printer”, then click “Next”.
Click on “Have Disk”.
In the “Install From Disk” window your 3.5” floppy drive should be pre-selected in the
“Install From Manufacturer’s Disk” box. If it is, click on OK. If necessary, change the
drive designation, then click on “OK”.
Click on Radius under “Manufacturer’s”, then click on Radius Engraver, then click on
“Next”.
Under “Available Ports” highlight LPT1: Printer Port, then click on “Next”.
Click on “Yes” or “No” depending on whether you want this to be the default printer.
“Yes” is recommended. Click on “Next”.
Click on “No” to printing a test page, then click on “Finish”. Your Radius print driver is
now installed.
Follow the above procedure to install the Radius Stamp driver.
It is recommended that you turn your computer off and restart it after you have installed a
new print driver.
SPECIAL NOTE TO COREL 5.0 USERS!
If you are using Corel version 5.0 you
must perform the following steps:
a)
Click on the “START” button at the bottom left of your screen.
b)
Click on “SETTINGS”
8
