Solution:
- Some operations with Text in some versions of CorelDRAW require the text to be
converted to curves. This command is located in one of the pull down menus.
Problem: Engraving appears weak.
Solution:
- All mirrors and lens need to be cleaned and inspected for damage. See section
thirteen for instructions. If you are unsure of the location of all of the mirrors on your
engraver please contact Technical Support.
-Verify that the lens is in correct focus.
-Verify correct speed and power settings for the type of material that you are
engraving on.
Problem: No laser beam but the engraver appears to be running normally.
Solution:
-Verify focus is set properly
-Verify power and speed settings are appropriate
Problem: Scanned images will not print or will not print correctly.
Solution:
-If you are using Corel 3.0 or 5.0 do not rotate your image.
Rotate the artwork before you scan it.
-If you are using Corel 5.0 verify that it is version G1.
To do this click on “Help” in Corel 5.0 then click on “About
CorelDraw”. If it is not revision G1 then contact Corel for the free upgrade. Be
prepared with your serial number of your Corel they will require it.
-If you are using Corel 6.0 or 7.0 there are three settings in
Corel that require the proper setting. Put some type of design
on your screen, a basic square will do. Then follow the instructions below.
Click on:
File
Print
Options
Then “Options” page
Then under “Special Settings” you will find the choice of
“Options” and “Setting”.
First find the option “Bitmap Printing”
Set it to “Output Entire Bitmap”
Then find the option “Driver Banding”
Set it to “ Send Bands to Driver”
Then find the option “Text Output Method”
Set it to “ All Text as Graphics”
-Verify that Corel 6.0 is version .176, follow the instructions above for verification and
updates
42
