10
Installation and Operating Instructions - EOS Herkules XL S120
General safety instructions
EN
Sauna cabin and
heater
The sauna cabin must be constructed with proper material and
built in a professional manner, and the heater must be suited for
the cabin.
The sauna heater may be installed only in sauna cabins made
from suitable, low-resin, and untreated material, e.g. Nordic
spruce or other materials suitable for sauna construction.
One or more than one sauna heater may be installed in a sauna.
The heater output must be able to accommodate the cabin vol-
ume in all cases. If multiple heaters are used, depending on
their position, an additional safety temperature limiter must be
installed for each additional heater.
The sauna heater is not designed to be installed or set up in an
alcove or under a bench or sloping roof unless the sauna heater
is specifically designed and approved for this type of installa-
tion.
Receptacles may not be installed inside the sauna cabin.
Each sauna cabin must have air inlets and outlets. The air inlets
and outlets may be installed below or behind the sauna heater,
approx. 5 to 10 cm above the floor. The minimum dimensions
of the air inlets and outlets can be found here: 2.4 Technical
data,
The exhaust openings are always installed in the lower part of
the wall diagonal to the sauna heater. The supply and exhaust
openings must not be closed. Please observe the instructions
provided by your sauna cabin manufacturer.
Use one of the control units listed below to check and control
the sauna heater. This control unit is fixed to a suitable location
on the cabin's external wall, and the corresponding sensor
housings according to the installation instructions that accom-
pany the control units inside the sauna cabin.
The cabin lighting must be safe for sauna cabin use and in-
stalled in such a way that it can be used safely in a sauna cabin.
Ensure that the heater is installed in compliance with the stand-
ards and legal norms valid in your country. In CENELEC member
states, the cabin lighting must be “protected from splash water”
as defined in DIN EN VDE 0100 T 703. Only one sauna light with
a maximum of 40 W may be installed with this sauna heater.
The cabin must not have a locking device that cannot be un-
locked as needed. We recommend magnetic or spring locks.
