Enterasys SBUQHS/QHB, User Manual

Page: 40 / 96

Command Port Interface (SBUQLS/QLB)
80-14001000-03 3–11
J) LAL
CONTROL
Selects if the loop pin on the SBUQLS/QLB is
enabled (pin 18 on the V.24 rear interface card, pin
L on V.35 rear interface card)
A) DISABLED (F) Disables the loop pin input.
B) ENABLED Enables the loop pin input.
3.4.3.2 Call control menu
A) ANSWER Determines how the SBUQLS/QLB responds to an
incoming call.
A) AUTO (F) Answers an incoming call
automatically.
B) CLID Answers the call only if the
originating number matches
a number in the CLID store.
Otherwise the call is
rejected.
C) MANUAL Awaits the user to command
the SBUQLS/QLB to answer.
D) CALL BACK
3
The incoming call’s
originating number is
checked against the CLID
store, the call is then cleared,
then the originator is called
back also using the sub-
address (if one is entered) in
the CLID store.
3
With Call Back enabled, the Delay After Attempt in the Cyclic Dial menu
must be set to at least 6 seconds at the calling unit, to allow for the call back
to occur.