2-10
ENSTROM 280FX OPERATOR’S MANUAL
FAA Approved: Mar 26/12
Rev. 6
Report No. 28-AC-020
Feb 21/12
2-12. Placards
1. Placards that are required to be placed in view of the pilot
are:
a.
THIS HELICOPTER MUST BE OPERATED IN
COMPLIANCE WITH THE OPERATING
LIMITATIONS SPECIFIED IN THE FAA
APPROVED ROTORCRAFT FLIGHT MANUAL
b. Placards for 280FX V
NE
(located overhead above center
windshield):
(1)
V
NE
placards shown in Figure 2-1 and Figure 2-2
are used on all 280FX helicopters serial number
2132 and prior.
(2)
V
NE
placards shown in Figure 2-3 and Figure 2-4
are used on all 280FX helicopters serial number
2133 and subsequent. 280FX helicopters serial
number 2132 and prior may also use these
placards.
c. Smoking restrictions – (This placard is not required if
approved ashtray is installed.)
NO SMOKING
d.
THIS HELICOPTER IS APPROVED FOR
OPERATION UNDER DAY AND NIGHT VFR NON-
ICING CONDITIONS ONLY
e. This placard is to be placed adjacent to the collective
friction device.
COLLECTIVE FRICTION TO BE USED FOR
GROUND OPERATION ONLY
This electronic document is not linked to a subscription for revision control or distribution. Refer to theTechnical
Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
level of the 280FX Rotorcraft Flight Manual.
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
