Enovation Controls Murphy EMS PRO LITE, Installation And Operation Manual

Page: 38 / 63

Section 40 00-02-0787
2015-03-23
~ 30 ~
S-# Description
S56 PSI XDUCER MIN CNT: (S45 is only visible if S35 = Transducer &
S37 = Pressure.) With 1 VDC or 4mA applied to the analog channel,
make the top line read the same value as the bottom line.
Factory set
to 181. (If transducer is 0-5 VDC, enter 0 in this set point)
S57 START LEVEL: (S57 is only visible if S35 = Transducer and S37 =
Level.) When “level” is selected in the start / stop type, an auto start
will occur when the system level reaches this set point. (adjustable
from 0 to 100.0 FT)
Factory set to 15.0 FT.
S58 STOP LEVEL: (S58 is only visible if S35 = Transducer and S37 =
Level.) When “level” is selected in the start / stop type, an auto stop
will occur when the system level reaches this set point. (adjustable
from 0 to 100.0 FT)
Factory set to 5.0 FT.
S59 MAINTAIN LEVEL: (S59 is only visible if S35 = Transducer and S37 =
Level.) When “level” is selected in the throttle type, the engine will be
throttled between the “minimum” and “maximum” rpm set points to
maintain this level. (adjustable from 0 to 100.0 FT)
Factory set to
10.0 FT.
S60
DEADBAND LEVEL: (S60 is only visible if S35 = Transducer and S37
= Level.) When “level” is selected in the throttle type, no throttling will
occur while the level is in the deadband. This set point extends above
and below the maintain set point. (adjustable from 0 to 100.0 FT)
Factory set to 1.0 FT.
S61 LEVEL OFFSET: (S61 is only visible if S35 = Transducer and S37 =
Level.) Enter in feet the distance from the bottom of the tank or sump
to the transducer. This value is added to the actual level reading.
Factory set to 0.0