ENFORCER
Heavy-Duty Outdoor Access Control Keypad with Proximity Reader
SECO-LARM U.S.A., Inc.
7
LED Indicators and Keypad Sounds:
IMPORTANT NOTES:
LED Indicators
Red LED (left)
Amber LED (center)
Green/Red LED (right)
Steady
Output #1 inhibited
Programming mode
Output #1 activated (green)
Output #2 activated (red)
Flashing
Inhibit mode paused
Standby mode
Keypad Sounds and LEDs
Status
Sounds*
Amber LED (center)
In programming mode
–
Steady ON
Successful key entry
1 Beep
1 Flash
Successful code/card entry
2 Beeps
2 Flashes
Unsuccessful code/card entry
5 Beeps
5 Flashes
Power up delay
Continuous beeping
Continuous flashing
Output relay activation**
1sec long beep
–
In standby mode***
–
1 Flash/sec
System restore mode
2 Beeps
Fast flashing for 2.5 min
Card/code already stored
1 Long beep
–
Real-time clock stopped after
power loss
Continuous 3 fast beeps every 5
seconds
–
*Keypad sounds can be programmed ON or OFF (see pg. 29)
**Output relay activation sounds can be programmed for 1 second long beep, 2 short beeps,
or OFF (see pg. 29)
***Amber LED flashing during standby mode can be programmed ON or OFF (see pg. 29)
IF USING THE KEYPAD WITH A MECHANICALLY
OPERATED DOOR OR GATE, MOUNT THE KEYPAD AT
LEAST 15’ (5m) FROM THE DOOR OR GATE TO PREVENT
USERS FROM BEING CRUSHED OR PINNED. FAILURE TO
DO SO MAY RESULT IN SERIOUS INJURY OR DEATH.
1.
Always disconnect power before servicing the keypad. Do not apply power until all connection
wiring is completed.
2.
The keypad must be properly grounded. Use a minimum 22AWG wire connected to the
common ground output. Failure to do so may damage the keypad.
3.
Allow at least 2ft (60cm) between this and any other keypads to avoid interference.
4.
All wiring and programming should be done by a professional installer to reduce the risk of
improper installation.
5.
The user’s guide for this keypad is located on pg. 34 of this manual.
6.
Be sure to store this manual in a safe place for future reference.
