ENFORCER
Heavy-Duty Outdoor Access Control Keypad with Proximity Reader
SECO-LARM U.S.A., Inc.
15
Getting Ready to Program (Continued):
System Restore:
System restore will reset all programming values except the master programming code back to
default values shown on
pg. 16.
1.
Make sure the keypad is in programming mode (see "Enter and Exit Programming Mode,"
pgs. 14~15):
2.
Initiate system restore:
NOTES:
•
System restore will reset ALL programming except the master programming code back to default
values. Be careful to use system restore only when absolutely necessary.
•
System restore may take several minutes. The amber LED will flash rapidly during this time.
•
Once system restore has been completed, the keypad will beep twice to show that all
programming values have been reset to their default values and are ready to be re-programmed.
•
At this point, the keypad is still in programming mode.
2.
Exit programming mode:
The
entry can be used to exit programming mode at any time while programming. The
amber LED will return to flashing, indicating standby mode, upon exiting programming mode.
NOTE:
DO NOT DISCONNECT THE KEYPAD FROM POWER WHILE IN
PROGRAMMING
MODE
. Disconnecting the keypad while in programming mode could cause a keypad
memory error.
