ENFORCER
Heavy-Duty Outdoor Access Control Keypad with Proximity Reader
SECO-LARM U.S.A., Inc.
29
Programming the Amber LED Flashing During Standby Mode:
Programming the Output Relay Activation Sounds:
Programming the Keypad Sounds:
Programming the User Code Entry Mode (Continued):
The keypad’s amber LED typically flashes while the keypad is in standby mode, but can be
programmed off if needed.
•
Enable amber LED flashing during standby mode (default):
•
Disable amber LED flashing during standby mode:
The keypad output sounds can be programmed for one of three modes:
•
No beeps – The keypad will not beep when an output is activated:
•
1-second beep (default) – The keypad will beep for 1 second when an output is activated:
•
2 short beeps – The keypad will beep twice when an output is activated:
NOTE:
This programming function only impacts the output relay activation sounds. It does not
impact the keypad sounds (see "Programming the Keypad Sounds" above).
Some of the keypad sounds can be programmed off:
•
Keypad audible mode –
All the keypad’s status beeps are enabled.
•
Keypad silent mode – The successful key entry beep (1 beep) and the unsuccessful user code or
card entry beeps (5 beeps) are disabled. However, the warning and power-up delay beeps
remain active. This provides for a quieter work environment.
To Program:
•
To enable keypad audible mode: (default):
•
To enable keypad silent mode:
NOTE:
This programming function only impacts the keypad sounds. It does not impact the output
relay activation sounds (see "Programming the Output Relay Activation Sounds" below).
NOTE:
If the keypad was previously programmed for manual code entry mode and then is
reprogrammed for auto entry mode, any codes whose length exceeds the number of digits
of the master programming code will no longer operate the keypad. However, if the keypad
is reprogrammed for manual entry mode, the longer codes will again operate the keypad.
