Emerson PACSystems RX3i, User Manual

Page: 79 / 164

RSTI-EP PROFINET I/O Controller User Manual Section 3
GFK-2571R May 2021
Configuration 72
Figure 68: VersaMax PNS Rack showing Power Supply Located between I/O Modules
3.7.5 Configuring VersaMax Module Parameters
After adding VersaMax modules to the remote node, the parameters for each must be
configured. For all VersaMax modules, this includes configuring a set of basic parameters
(such as: Reference Address, Length, Scan Set, Carrier, Report Faults). Configuration details
for those basic parameters are provided in the Configuration Section of the VersaMax
PROFINET Scanner Manual, GFK 2721.
Configuring Analog Modules Requiring Jumper Settings
The following VersaMax analog modules use jumpers to select their voltage / current
operation or output defaults mode.
CAT Number Description
IC200ALG230 Analog Input Module, 12-bit Voltage/Current 4 Channels
IC200ALG260 Analog Input Module, 12-bit Voltage/Current 8 Channels
IC200ALG262 Analog Input Module, 15-bit Current Differential 8 Channels
IC200ALG264 Analog Input Module, 15-bit Current 15 Channels
IC200ALG266 Analog Input 15-bit Current 15Ch with enhanced over voltage
protection
IC200ALG320 Analog Output Module, 12-bit Current, 4 Channels
IC200ALG321 Analog Output Module, 12-bit Voltage 4 Channels. 0 to +10Vdc Range
IC200ALG322 Analog Output Module, 12-bit Voltage 4 Channels. -10 to +10Vdc Range
IC200ALG325 Analog Output Module, 13-bit Voltage 8 Channels
IC200ALG326 Analog Output Module, 13-bit Current 8 Channels
IC200ALG327 Analog Output Module, 13-bit Voltage 12 Channels
IC200ALG328 Analog Output Module, 13-bit Current 12 Channels