Hardness Tester
Introduction
DuraJet 10 G5
1-2
Do not work with the machine for too long or when you are unable to concentrate
properly.
The machine must not come into contact with water. Protect the machine from
splashing.
Before each startup, ensure that the machine is in a flawless condition and that none of
the safety features have been removed and are all functional. Any damaged cables
must be replaced immediately by authorized personnel.
Ensure that the machine is only operated by authorized and properly trained persons.
Ensure that the machine cannot be started or operated by unauthorized persons.
Ensure that the machine is only operated by one person at all times.
Do not make any unauthorized changes to the machine's safety features. Bridging of
control features and any interference with the electrical/electronic components of the
machine are not permitted and will nullify the warranty in all cases.
In case of emergency, shut down the machine immediately with the EMERGENCY-OFF
button.
Before testing, check that the testing tools are securely clamped.
Do NOT attempt to touch the internal parts of the machine while it is operating.
Use appropriate fixings to secure any workpieces that do not stay in place without
support.
Never hold workpieces in place by hand!
Wear protective gloves when handling heavy or sharp workpieces or removing chips.
Use the main switch to turn the machine off before resetting.
Never leave the machine unsupervised while it is operating. Always switch the machine
off before leaving the work station.
Keep your work station clean and tidy. A cluttered work station increases the risk of
injury.
Use the main switch to turn the machine off. Remove the power plug to disconnect the
machine from the power supply before you carry out any maintenance or readjustments.
Any work on the machine's electrical parts unit should only be carried out by skilled
electricians or service technicians.
Comply with the stipulated inspection and maintenance intervals (see standards EN ISO
6507, EN ISO 6505, EN ISO 6508, EN ISO 4545, EN ISO 2039).
Contact your supplier in the event of collision or damage. Always specify the unit
number and software version of your machine in cases of complaint or damage or when
making inquiries or ordering replacement parts.
Work time
Protection from
splashing
Startup
Operation by
authorized personnel
Single-person machine
Unauthorized changes
EMERGENCY-OFF
Securing workpieces
Resetting the machine
Supervision
Work station
Maintenance
Claims
