VP-12, VP-12P IP phones. Operation manual
58
Access to the Internet service
To get device access from the Internet service interfaces, set the following permissions:
Web
•
HTTP
– when selected, connection to the device web configurator is enabled via HTTP (insecure
connection);
•
HTTPS
–
when selected, connection to the device web configurator is enabled via HTTPS (secure
connection).
Telnet
– a protocol that allows you to establish mechanisms of control over the network. Allows you to
remotely connect to the gateway from a computer for configuration and management purposes. To enable the
device access via Telmet protocol , select the appropriate checkboxes.
SSH
–
is a secure device remote control protocol. However, as opposed to Telnet, SSH encrypts all traffic,
including passwords being transferred. To enable the device access via SSH protocol , select the appropriate
checkboxes.
Access to VoIP Service
In this section you may configure access to VoIP service interface (to configure VoIP service interface, use
VoIP—Network configuration) through the web (HTTP or HTTPS), and also via Telnet and SSH protocols. To
enable access to any protocols listed above, select the appropriate checkboxes
Access to Management Interface Service
Use this section to configure access for the device management via HTTP, HTTPS, Telnet and SSH. To
configure the interface, use
System
—
Management VLAN
page.To enable access to any protocols listed above,
select the appropriate checkboxes.
Access to the menu elements
This block includes 3 groups of items, access to which can be denied for a user. If one or another item is
specified in the list, then access to it is allowed.
You can deny access by clicking
to the right of menu item name. To allow access to a previously
denied menu item, you should click on the
button and select the required item from the drop-down list.
To provide the administrator with access to all menu items, including hidden from the user, you should switch
to the admin mode.
For Telnet and SSH protocol authorization, you may use default username
admin
and password
password
. After authorization, Linux console will become available that supports basic commands of
the 'shell' command interpreter.
For access to hidden menu items the same password is used as for the access to web interface.
