VP-12, VP-12P IP phones. Operation manual
21
• Static – specifying access settings manually: IP address, subnet mask, DNS server, gateway;
•
Use the Secondary Access for VoIP
– this option is available, if there are no dedicated interfaces for VoIP
service ('Use Internet settings' checkbox is selected). When the checkbox is not selected (default value),
VoIP service uses PPP interface for its operation; when selected, the secondary access interface (IPoE).
•
Alternative Vendor ID (Option 60) –
when selected, the device transmits Vendor ID (Option 60) field value
in Option 60 DHCP messages (Vendor class ID). If the field is empty, Option 60 will not be transmitted in
DHCP messages:
[VENDOR:
device vendor
][DEVICE:
device type
][HW:
hardware version
] [SN:
serial number
][WAN:
WAN
interface MAC address
][LAN:
LAN interface MAC address
][VERSION:
firmware version
]
Example: [VENDOR:Eltex][DEVICE:VP-12P][HW:1.0][SN:VI23000118] [WAN:A8:F9:4B:03:2A:D0][LAN:
02:20:80:a8:f9:4b][VERSION:#1.1.0]
•
Vendor
ID
(
Option 60
) – o
ption 60 value (Vendor class ID) which is transmitted in
DHCP messages. When the field is empty, option 60 is not transmitted in DHCP
messages.
Use VLAN
VLAN – a virtual local area network. VLAN is a group of hosts united in a network not depending on the
physical location. The devices grouped to a VLAN have the same identifier VLAN-ID.
•
Use VLAN
– use VLAN identifier specified below to enter the network.
•
VLAN ID
– VLAN identifier which is used for the device.
•
802.1P
– 802.1P attribute (also called CoS – Class of Service) is attached to egress IP packets.
The value is from 0 (the least priority) to 7 (the highest priority).
When you choose one of the way of IP addresses assignment, the addiitonal parameters
will be displayed according to the selected protocol.
